Request A FREE Catalog

become a dealer
 

You're currently on:

1932-1947 Early V8 Ford Truck Pickup Car Care, Protection, and Tools

Items 1 to 24 of 40 total Page:
  1. 1
  2. 2
  3. Next Page
Show per page
View as: Grid  List  Sort by Set Descending Direction
Hinge Pin Removal Tool Kit - Heavy-Duty Forged Steel Body

Includes instructions, heavy-duty forged steel body.


Pre-soaking the hinge pins with your preferred penetrant, along with this tool. will assist in removing those stubborn hinges.


Includes seven push pins of various diameters and lengths.


Makes a tough job easy without damaging the hinge or paint.






Learn More
$27.49 Kit

Add to Wishlist

Edelbrock 9290 A/B Epoxy Kit (1-Lb)
Easy to use A/B epoxy is a two part epoxy that is great for cylinder head and intake modifications. Simply mix the two parts, apply and let cure. Once cured, it can be sanded to shape, drilled and tapped. Wash hands well after handling.
Learn More
$34.99 ea.

Add to Wishlist

Oil 600W - For Rear End & Transmission - 1 Quart Bottle

  • This 600 Weight Oil Is Necessary For Many Early Fords
  • It Is Nearly Impossible To Find Locally
  • It Saw Use In Differentials, Transmissions, And Steering Boxes
  • Will Not Attack Brass Or Bronze Parts
  • One Quart


The lubricant used in the early days of motoring up into the thirties was a very heavy clinging type of lubricant known as 600 W Oil. In viscosity it is very much like today’s S. A. E. 250 Gear Oil but is easier on soft metals.  It was used in differentials because full floating rear axles were not in general use, and allowance had to be made in the seals to allow the axle to move up and down as far as a quarter inch. To prevent the oil from leaking at the wheels the lubricant was made to cling to the gears.  The same principle applies to transmissions and steering boxes.  

In today's cars the seals can be made to fit very closely due to better engineering and materials, therefore lighter weight lubricants are used.  The main causes of oil leaking at the rear wheels are worn seals or bearings, but over filling and/or using a lighter weight lubricant than recommended can also cause leaks.  This 600W oil comes in a quart bottle, and it contains no additives that could attack brass or bronze parts. Using this weight lube will help eliminate oil seal leaks.

TIP: Leave rear axle 600W 3/4 inches below filler opening; overfilling is the main cause of rear axle leaks.


Learn More
$8.99 ea.

Add to Wishlist

Engine Paint - Ford Green Enamel - 11 Oz. Spray Can

Dries in minutes. Heat resistant up to 300 degrees F.





This product may appear to be very dark at application. Although colors varied, this is the correct FORD ENGINE GREEN dark green color for Ford engines from 1927-1941. According to judging standards, all engine parts correctly painted Ford Engine green must match. There is no mention of any correct green color.






Learn More
$7.79 ea.

Add to Wishlist

Grease Gun Fitting Adapter - Adapts Modern Grease Gun To Work With Original Style Grease Fittings

Threads onto the end of a grease gun. Eliminates the mess of oozing lubrication.


Provides a positive coupling between lube gun & original, cone style fittings.









Learn More
$4.99 ea.

Add to Wishlist

Engine Paint - Ford Green - 1 Quart Can - Quick-Drying Enamel

Heat resistant up to 300 degrees F.





This product may appear to be very dark at application. Although colors varied, this is the correct FORD ENGINE GREEN dark green color for Ford engines from 1927-1941. According to judging standards, all engine parts correctly painted Ford Engine green must match. There is no mention of any correct green color.






Learn More
$24.99 QT

Add to Wishlist

Gas Tank Sealer - Ethanol Compatible - 1 Quart Can

With its ability to bond to all metal or fiberglass tanks, it will stop rust, leaks & corrosion permanently. Formulated to be resistant to alcohol & all fuels including Phase II oxygenated types (Ethanol E10). With easy to follow instructions included, this one quart can is enough to treat several tanks.












Learn More
$31.49 QT

Add to Wishlist

Spark Plug Compression Adapter - 4 Cylinder Model B

For adapting a modern compression tester to a Model B spark plug hole.






Learn More
$7.99 ea.

Add to Wishlist

Brake Shoe Lining Riveting Tool - Removes and Installs

Great tool, makes a tough job easier.


With detailed instructions.






Learn More
$24.49 ea.

Add to Wishlist

Engine Paint - Ford Blue Enamel - 11 Oz. Spray Can

Quick-drying and heat-resistant.


Also 41-48 Ford Commercial Truck.






Learn More
$9.99 ea.

Add to Wishlist

Gas Tank Etch - 1 Pint Bottle

Use as a prep for your tank, before applying the tank sealer (RSP22A). Removes light buildup of rust from inside the tank & leaves a gray phosphate coating. 1 pint should handle up to a 30-gallon tank. Non-Toxic & Non-Flammable, Bio-Degradable. 16 FL.OZ.












Learn More
$12.99 ea.

Add to Wishlist

Running Board Contact Cement - 1 Pint Can - Neoprene Adhesive

For rubber to metal applications, enough for one car.






Learn More
$15.99 PT

Add to Wishlist

Rear Axle Wheel Puller - Zinc Plated - Knock Off Type - Ford

Remove the rear axle nut & washer, screw on the knock-off tool & hit the end of the tool with a hammer to loosen the wheel.









Learn More
$4.49 ea.

Add to Wishlist

California Car Duster - Black Vinyl Carrying Case Included - 26 Long

The Original California Car Duster with a wooden handle is just the ticket to keeping your baby car show clean. Special baked-on wax treated cotton fiber strands lift dust without scratching paint. The dirtier it gets, the better it works! A black vinyl carrying case is included. Conveniently washable & ready to reuse.















Learn More
$29.99 ea.

Add to Wishlist

Cast Blast Hi-Temp - Withstands Up To 1200 Degrees - 12 Oz. Spray Can



  • 1200 Degree Durability

  • Great Coverage

  • Keeps Exhaust Manifolds Looking Great

  • Also Good For Brake Drums And Calipers 

  • Easy Touch-Up


 



 


Get that original look of cast iron with our cast iron gray spray paint. Excellent for use on engine blocks, manifolds, cylinder heads and any other parts that you desire to give that cast iron appearance. This product must be shipped via ground service to continental US addresses. It cannot ship internationally. 


Learn More
$12.99 ea.

Add to Wishlist

Stromberg Jet Wrench - CNC Milled Stainless - Top Quality

This sturdy wrench will work on original & aftermarket jets. A premium version. Knurled top end for excellent control & a CNC milled pocket for precise accurate fit on the jet end. Cheaper wrenches have a punched end.


A genuine Stromberg brand part, Made in England.















Learn More
$30.99 ea.

Add to Wishlist

Insulating Varnish - 16 Oz. Spray Can

Won't char, crack or deteriorate. Reduces current leakage. Use on generator/ starter armatures & magneto coil assemblies.












Learn More
$8.49 ea.

Add to Wishlist

Cold Galvanizing Weld-thru Primer - Zinc - 15 Oz. Spray Can

Over 90% zinc provides a durable film and excellent rust protection.















Learn More
$13.49 ea.

Add to Wishlist

$11.99 ea.

Add to Wishlist

$11.99 ea.

Add to Wishlist

Alumi Blast - 12 Oz. Spray Can

Restores a new look to sandblasted parts.






Learn More
$9.49 ea.

Add to Wishlist

Dry Graphite Lube - 14 Oz. Spray Can

A fast drying lubricant that forms a thin, black film providing excellent anti-friction & anti-seizure properties to surfaces. All position valve allows can to be sprayed in any position.


Perfect for use between spring leaves, regulator gears, door latches & hood & truck latches.









Learn More
$11.49 ea.

Add to Wishlist

Items 1 to 24 of 40 total Page:
  1. 1
  2. 2
  3. Next Page
Show per page
View as: Grid  List  Sort by Set Descending Direction

Early V8 Ford Truck Pickup car care is important for the life of your V8 Ford Truck, not to mention maintaining the fresh from the showroom look. That's why MAC's carries a complete selection of car care products for the discriminating Early V8 Ford Pickup owner. All the car care products you could need for restoration and care are right here at MAC's, the one-stop shop for Early V8 Truck owners. MAC's offers Early V8 Ford Pickup Trucks and F1 parts from 1932-1947