Filter Your Results

Request A FREE Catalog

become a dealer
 

You're currently on:

1932-1947 Early V8 Ford Truck Tools and Specialty Tools

Items 1 to 24 of 148 total Page:
  1. 1
  2. 2
  3. 3
  4. 4
  5. 5
  6. Next Page
Show per page
View as: Grid  List  Sort by Set Descending Direction
Hinge Pin Removal Tool Kit - Heavy-Duty Forged Steel Body

Includes instructions, heavy-duty forged steel body.


Pre-soaking the hinge pins with your preferred penetrant, along with this tool. will assist in removing those stubborn hinges.


Includes seven push pins of various diameters and lengths.


Makes a tough job easy without damaging the hinge or paint.






Learn More
$27.49 Kit

Add to Wishlist

Hog Ring Set - Holds Upholstery To Springs - 100 Piece Set

These hold the upholstery to the seat springs.






Learn More
$3.99 Set

Add to Wishlist

Lacing Rivet Set Tool - Ford - USA

Made specifically to get in close and properly install the grille lacing rivets with ease.


The double anvil head makes a difficult job easier and the 8 inch plier handles give added leverage.















Learn More
$32.99 ea.

Add to Wishlist

Trim, Moulding and Emblem Tool Set - 5 Pieces

Made of heavy-duty flexible plastic, so they won't break or scratch your paint job, these tools can be used on any trim work on your vehicle. There is a tool for almost any job you can think of, like removing moulding at the fastener point or glued-on weatherstripping.


The fine chisel-edged tools allow you to do it all without damage. Just the tools you need to make an often difficult job much easier.












Learn More
$9.99 Set

Add to Wishlist

Rivet Upset Tool Set - 2 Pieces

Includes bucking bar, hand held, will roll any tubular rivet. Concave end fits rivet head to support the rivet while it is upset.






Learn More
$9.99 Set

Add to Wishlist

Bearing Grease Packer Kit - Universal - 4-1/2 Diameter Cone

Applies fresh grease evenly to any bearing. The old grease is forced out onto the cone for easy clean up.






Learn More
$11.49 Kit

Add to Wishlist

Cylinder Head Stud Thread Repair Kit - Helicoil Style - 8 Pieces - 4 Cylinder Ford Model B

Use a 29/64" tap drill bit.


For repairs of cylinder & manifold threads in the block.















Learn More
$32.99 Kit

Add to Wishlist

1932-35 Ford Wire Wheel Spoke Straightening Set


  • Tool set used to straighten bent spokes
  • Made of hardened steel
  • US made


 


Straight wheel spokes not only make your early Ford look better, they will also give you a better ride.


Learn More
$109.99 Set

Add to Wishlist

Ignition and Coil Polarity Tester Kit

Checks for correct coil polarity and presence of spark, comes with instructions, for 6 or 12 volt systems, negative or positive grounds. Installs between distributor cap &
coil wire.

Works with ALL types of remote coil spark ignition systems: points, magneto, transistor, high-energy, capacitor discharge, etc.



  • Works with 6 or 12 Volt, positive or negative battery systems!

  • Tells you if you need to reverse the polarity of the electron flow!

  • Works with all types of remote coil spark ignition systems!

  • Not for '32-41 V8 trucks

  • Instructions included



Learn More
$24.99 Kit
Temporarily Discontinued

Add to Wishlist

Grease Gun Fitting Adapter - Adapts Modern Grease Gun To Work With Original Style Grease Fittings

Threads onto the end of a grease gun. Eliminates the mess of oozing lubrication.


Provides a positive coupling between lube gun & original, cone style fittings.









Learn More
$4.99 ea.

Add to Wishlist

Clutch Disc Alignment Tool - Ford

Aligns disc with pilot bearing when installing a new disc.






Learn More
$4.99 ea.

Add to Wishlist

Water Pump Packing Wrench - 4 Cylinder Ford Model B

Do NOT over tighten the pack nut. Adjust incremently, just enough to stop leaking.






Learn More
$4.99 ea.

Add to Wishlist

Safety Wire - 1/4 Lb. Spool - .032 Diameter - Stainless Steel

Many uses, torque tube, flywheel-to-block, radius rods, rear motor mounts, transmission, hood hinges, etc. Approximately 90 feet. Safely secures drilled head bolts from backing out.















Learn More
$9.99 SP

Add to Wishlist

Adjustable Tappet Wrench - Flathead V8

Two pieces, one to hold the tappet (lifter), the other to turn adjuster screw.






Learn More
$11.99 ea.

Add to Wishlist

Windshield Setting Tool - Nylon

Made of a durable nylon material, with a flat chisel-end & a rounded end for inserting seals. It will not scratch or chip glass.






Learn More
$2.49 ea.

Add to Wishlist

Lug Nut Protectors - Nylon - Two Sizes

 



  • Made Of High-Impact Nylon

  • Fits Inside Wrench Or Airgun

  • Eliminates Possibility Of Damaging Bolts

  • Includes 3/4" &
    13/16" Sizes

  • Uses 7/8" &
    15/16" Sockets




 


Keep those chrome & stainless wheel lug nuts looking like new! Made of high-impact nylon, these lug nut protectors fit inside your wrench or airgun sockets and eliminate the possibility of damaging the finish of your hub bolt nuts when tightening or loosening. Two sizes are included; the 3/4" protector uses 7/8" socket & the 13/16" protector uses a 15/16" socket. Count on MAC's for all of your classic Ford needs.



Learn More
$4.99 PR

Add to Wishlist

Tie Rod End Adjusting Tool - Ford

For 1932-34, removes the threaded plugs in the tie rod or drag link ends. Large screwdriver style blade on end. Use with 7/8" wrench.









Learn More
$5.99 ea.

Add to Wishlist

Distributor Cam Wrench - With Z Bend - 4 Cylinder Ford Model B

Easier to use than A12113, designed so you don't need to remove the distributor body when using this wrench.


Z bend helps in getting wrench into proper angle.






Learn More
$2.99 ea.

Add to Wishlist

Spark Plug Compression Adapter - 4 Cylinder Model B

For adapting a modern compression tester to a Model B spark plug hole.






Learn More
$7.99 ea.

Add to Wishlist

Brake Shoe Adjusting Wedge Wrench - Ford

This tool slips over the square end of the adjuster wedge (A2041) to adjust the brakes. It makes a tough job easier.


USA made.









Learn More
$9.99 ea.

Add to Wishlist

Brake Shoe Lining Riveting Tool - Removes and Installs

Great tool, makes a tough job easier.


With detailed instructions.






Learn More
$24.49 ea.

Add to Wishlist

Headliner Installation Tool - Economy Version

A necessary tool to have if you plan on installing your headliner yourself.






Learn More
$11.49 ea.

Add to Wishlist

Items 1 to 24 of 148 total Page:
  1. 1
  2. 2
  3. 3
  4. 4
  5. 5
  6. Next Page
Show per page
View as: Grid  List  Sort by Set Descending Direction

At MAC's Antique Auto Parts, we know there is no substitute for having the right Early V8 Ford Truck tools if you want to get the job done right. We stock a wide variety of quality tools to help you save time and money, as well as help you avoid unnecessary damage to your restoration. Do yourself and your classic a favor, and invest in the right Early V8 Ford Pickup Truck tools today at the lowest price guaranteed.