1967-1970 Mustang Power Steering Control Valve with 5/16" Pressure Port, All 6-Cylinder and V8

• Brand new control valve with all new components
• Not a rebuilt unit, no core is required
• Features 5/16" pressure hose port
• Works for all 6-cylinder and V8 engines
• Fits 1967 Mustangs with 5/16" pressure hose port 
• Fits 1968-1970 Mustangs, all models and engines

When its time to replace your worn out steering control valve, you will usually experience inconsistant steering operation and unpleasant control issues while driving. Consider replacing your old worn out unit with a brand new one manufactured from all new components, and get your car steering like new again. This valve features a 5/16" pressure port and is a direct fit for your classic Ford using the same size line fitting. This valve works for all engine sizes, 6-cylinder or V8.  

NOTE: This control valve was used on many Ford and Mercury vehicles over many years. The original part was a quality piece of equipment, but it has several ways that it can fail. It is highly recommended that prior to the installation of your new valve, the steering system should be completely flushed to remove dirt, rust, moisture, metal shavings, worn fluid, and other contaminants. Failure to do so will result in early failure of a control valve. Also, consider replacing the steering ram, pump and hoses to start fresh with all new components to ensure system integrity and long service life. 

1967-1970 Mustang Steering Control Valve to fix your inconsistant steering operation and unpleasant control issues while driving.