Model A Ford Horn & Light Switch Rod - 44-31/32 - Gemmer Design

A horn button is included with each rod. USA made. If possible, measure your light switch rod from the top of the rod under the light switch to the keeper groove just before the bottom end. 90% of 1928-29 vehicles used B style rods & 90% of 1930-31 vehicles used H style rods. Some reproduction rods will not fit into the steering shaft. Test the shaft by sliding the reproduction rod in from the worm end. If it will enter it will be fine, except for the last 1-1/2" from the threaded end. To correct the end, use a 3/8" drill to open the 1-1/2" of the shaft for the rod to fit. After drilling, clean out fittings using a long wire with a cloth tied to the end. Die-cast Chrome, the rod is plain finish Aluminum.